Hi, First off I'm not finished with this project and secondly I am aware that my skills seem to be well below the standard of most other posters!!
However I did see a query asking about a plinth template for a 72 and there wasn't one available at the time.
This one seems to work if it helps anyone get started, 18mm ply outside dimensions 370x295. It's a bit rough but no-one will see it and the figures may be a mil or two out in places; as I say it may be a useful start point for someone. A further blank piece is also needed and obviously you need to add a surrounding box to your own dimensions and design.
Good Luck, Mark
![](http://i.imgur.com/Rc0HHUth.jpg#CqLIo)
![](http://i.imgur.com/yZGNiLgh.jpg#CqLIo)
![](http://i.imgur.com/SpcYUjxh.jpg#CqLIo)